Maytag Washer Error Code CL

CL stands for Clear and is a prompt from the washer's control board to reset its internal cycle count registers. It is not a fault code and does not mean the washer is broken. The code appears after the machine has logged a set number of wash cycles. Performing the clear sequence on the control panel will dismiss the prompt and reset the count.

Yes, the CL code is an informational prompt and does not indicate a safety hazard or mechanical failure. Your washer should continue to operate normally while the code is displayed. You can address the reset at your convenience without any risk to the machine or your laundry.

In most cases, resolving the CL code costs nothing because it only requires a control panel button sequence to reset the cycle counts. If the code is caused by a faulty control board or user interface board, replacement parts and labor could range from roughly 150 dollars to 400 dollars or more depending on the specific board and service rates in your area.

To resolve the CL prompt, you need to perform a cycle count reset using the button sequence specified for your model, typically found in the diagnostic or service section of your washer's documentation. This clears the stored count data from the control board memory and removes the CL display. No tools or parts are required to complete this process.

A simple power reset by unplugging the unit may not clear the CL code because the cycle count data is stored in the control board's non-volatile memory. The proper way to clear it is through the designated cycle count reset button sequence on the control panel. If the code returns immediately after performing the correct clear procedure, the control board may need further inspection.