Maytag Washer Error Code door

The door error on a Maytag washer means the control board is not receiving a signal that the door is closed and latched. The washer pauses or refuses to run to prevent water from spilling out of an unsealed drum. This can result from the door simply being ajar, an obstruction in the doorway, or a fault in the door latch or its switch.

A reset may clear the displayed error code temporarily, but if the underlying latch or switch problem is not resolved, the error will return as soon as you try to run a cycle. The control board will keep detecting an open-door condition until the hardware fault is corrected. Always address the physical cause before relying on a reset.

If the fix is simply closing the door or removing a trapped item, there is no cost involved. Replacing a door latch assembly typically runs between $20 and $80 for the part, depending on the model. If a technician is needed for diagnosis and installation, total repair costs including labor generally range from $100 to $250.

Start by firmly pressing the door closed until you hear the latch click, then check whether the error clears. If it persists, inspect the door opening for trapped laundry or debris blocking the seal. If the latch itself is cracked or the lock switch has failed, those components will need to be replaced to restore proper operation.

No. The washer intentionally pauses when this error appears because running a cycle with an unlatched or unsealed door can result in water leaking onto the floor. Do not attempt to force a cycle to run while the error is active. Resolve the latch issue first to ensure the door seals properly before running any wash cycle.