Maytag Washer Error Code F/14

F/14 indicates that the Central Control Unit cannot properly read data from its onboard EEPROM memory chip. The EEPROM stores the washer's operating parameters and cycle settings, and when the CCU loses access to that data, it stops the cycle and displays this fault code. The cause can range from a temporary data glitch after a power event to a fully failed control board.

Start by unplugging the washer for two minutes to allow the CCU to fully reset, then run a Diagnostic cycle to check if the fault clears. If the code returns, inspect all wire harness connectors at the CCU for corrosion or loose terminals and reseat them firmly. A persistent F/14 that survives a reset and a connector inspection points to a failed CCU board that will need to be replaced.

If the issue is resolved by a power reset alone, there is no parts cost involved. If the CCU board requires replacement, parts typically range from roughly 150 to 350 dollars depending on the specific model, with professional labor adding another 100 to 200 dollars in most markets. Diagnosing the fault yourself before calling a technician can help you decide whether repair or replacement is the more practical option.

A reset will clear F/14 if the cause was a temporary power-related data glitch. Unplug the washer or disconnect it from the circuit breaker for a full two minutes, then restore power and run a Diagnostic test or a normal cycle to confirm the error is gone. If the F/14 code returns after the reset, the CCU board likely has a hardware fault that a power cycle cannot fix.

The washer will typically stop operation when the F/14 fault is active, so running full cycles is not possible until the error is resolved. Continuing to attempt cycles with an unresolved CCU fault is not recommended, as the control board governs water fill, motor operation, and drain timing. Address the fault before regular use to avoid potential overflow or operational issues.