Maytag Washer Error Code E2

The E2 code on a Maytag washer means the control board has detected a key on the console keypad that has been held down for more than 30 seconds. The control assumes the key is physically stuck rather than being pressed intentionally. The error is designed to prevent unintended washer operation caused by a malfunctioning button. The issue is typically located in the keypad membrane or the connection between the keypad and the control board.

It is not recommended to continue using the washer while E2 is active. A stuck key input can cause the machine to behave unpredictably or execute unintended cycles. Resolve the fault before running additional loads to avoid potential damage to the washer or laundry.

If the fix is simply reseating the ribbon cable connection, there is no parts cost and the repair can be done at no charge. If the console assembly needs to be replaced, parts costs typically range from around $80 to $200 or more depending on the specific model, with professional labor adding $100 to $200 on top of that. Diagnosing the exact failed component before ordering parts is the best way to avoid unnecessary expense.

In some cases, yes. Start by checking that nothing is resting against the control panel and pressing a button, then press each button individually to see if any feel stuck or fail to spring back. If the keypad ribbon cable connection to the control board is loose, reseating it may resolve the error. If the keypad membrane itself has failed, replacing the console assembly is the required repair, which is a task many experienced DIYers can complete.

A power reset may temporarily clear the E2 code, but the error will return if the underlying cause is not fixed. If a keypad button is physically stuck or the membrane has failed internally, the fault condition will persist through any number of resets. A reset is useful for confirming whether the issue is intermittent, but it is not a lasting solution.