Model reference
Maytag MAH6700A
Washer
7 documents18 error codes12 service modes
Available documentation
Tech Sheet
- 27" Front Load Washer - Technical Information13 pg
Service Manual
- Maytag Neptune 27" Front Load Washer L2005-00452 pg
Bulletin
- Technical Bulletin - Washer Vibration/Walking/Noise on 27" Neptune washers6 pg
- Technical Bulletin - Vibration / Walking / Noise Reduction4 pg
Training
- Maytag Neptune 27" Front Load Washer52 pg
Other
- Maytag Neptune MAH6700AW68 pg
- 160272058 pg
MyPros+ Max
Diagnose your Maytag MAH6700A.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (18)
CodeMeaning
2EVoltage for motor control bus is under specified limit.3EOver Current is detectedbEMotor tach signal exists without motor running (tach signal exists without…dcNever exceeded 400 rpm due to an unbalanced load during final spin.dLOpen door lock switch with motor runningdSDoor switch is read as open and the door locked switch is read as locked during…E2A key is sensed to be pressed more than 30 seconds; the key will be assumed to…E3Machine control is attempting to drive the motor but is not seeing any tach…FLDoor failed to lock after 3 attempts.LEWater sensor level faultLODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15…nFContinuous fill of 12 minutesodThe door has not been opened after two complete wash cyclesOEA fault is detected in the water level sensorSrSystem Relay failureSuWasher is in suds periodtEAbnormal high/low temperature or ohm resistance seen from sump thermistor.Service modes (12)
- Board Input TestWhile in Service Mode, press the Spin & Drain key
- Board Output TestWhile in Service Mode, press the Spin Speed key.
- Clear All Diagnostic CodesWhile viewing diagnostic codes in Service Mode, press Delay Start and Chime keys together for 3…
- Cycle CountWhile in Service Mode, press Chime key.
- diagnosticRefer to the Technical Data Sheet shipped with the product for service mode diagnostics entry…
- Diagnostic Code DisplayWhile in Service Mode, press Rinse & Spin key
- Display Software VersionWhile in Service Mode, press Soil Level
- Fast Time Down TestWhile any test or cycle is running in Service Mode, press the Wash/Rinse Temp key to advance to the…
- LED/Switch TestWhile in Service Mode, press the Delay Start key for 3 seconds
- Quick Service CycleWhile in Service Mode, press Wash/Rinse Temp and Soil Level keys simultaneously for 3 seconds.
- Quick Spin TestWhile in Service Mode, press Delay Start and Rinse & Spin keys.
- Service Mode1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass