mypros+
Model reference

Maytag MAH6700AWM

Washer

32 documents19 error codes18 service modes

Available documentation

Service Manual

  • servicemanual 1602618668 pg
    Covers this model
  • Maytag Neptune 27" Front Load Washer L2005-00452 pg
    Covers this model

Tech Sheet

  • 27" Front Load Washer - Technical Information13 pg
    Covers this model
  • Maytag MAH6700 Washer Tech Sheet13 pg
    Covers this model
  • 27" Front Load Washer⎯Technical Information15 pg
    Covers this model

Bulletin

  • Technical Bulletin - TDL-0117-B revised rear outer tub and software change1 pg
    Covers this model
  • Technical Bulletin - TDL-0101-B-French Reinstalling Shipping Bolts1 pg
    Covers this model
  • Technical Bulletin - TDL-0117-B-French revised rear outer tub and software change1 pg
    Covers this model
  • Technical Bulletin - TDL-0101-B Reinstalling Shipping Bolts1 pg
    Covers this model
  • Technical Bulletin - IDL-0002A-B Units Delivered in Sales Mode1 pg
    Covers this model
  • Technical Bulletin - E3 and dc codes1 pg
    Covers this model
  • Technical Bulletin - IDL-0002A-B-French Units Delivered in Sales Mode1 pg
    Covers this model
  • Technical Bulletin - TDL-0078A-B EC and DC Codes2 pg
    Covers this model
  • Technical Bulletin - TDL-0078A-B EC and DC Codes2 pg
    Covers this model
  • Technical Bulletin - Restricted Dispenser Hose1 pg
    Covers this model
  • Technical Bulletin - TDL-0091-B1 pg
    Covers this model
  • Technical Bulletin - Motion sensor wire harness installation1 pg
    Covers this model
  • Technical Bulletin - TDL-0082-B Restricted Dispenser Hose1 pg
    Covers this model
  • Technical Bulletin TDL-0121-S1 pg
    Covers this model
  • Sourced laundry console removal procedure1 pg
    Covers this model
  • Technical Bulletin - IDL-0003-B-French MAL1800AX Pedestal Installations5 pg
    Covers this model
  • Technical Bulletin - IDL-0003-B MAL1800AX Pedestal Installations5 pg
    Covers this model
  • Technical Bulletin - IDL-0003-B MAL1800AX Pedestal Installations5 pg
    Covers this model
  • Technical Bulletin - Washer Vibration/Walking/Noise on 27" Neptune washers6 pg
    Covers this model
  • Technical Bulletin - Vibration / Walking / Noise Reduction4 pg
    Covers this model

Service Flash

  • Instruction Sheet8 pg
    Covers this model

Tech Tip

  • Instruction Sheet4 pg
    Covers this model

Training

  • Maytag Neptune 27" Front Load Washer52 pg
    Covers this model

Other

  • 160273204 pg
    Covers this model
  • Maytag Neptune MAH6700AW68 pg
    Covers this model
  • 160272058 pg
    Covers this model

Installation Guide

  • Bulletin d'installation - Installations du socle pour la MAL1800AX5 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MAH6700AWM.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (19)

CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EOver Current detectedbEMotor tach signal exists without motor running or when not expected.dcUnbalanced loaddLOpen door lock switch detected with motor running.dSDoor switch is read as open and the door locked switch is read as locked.E2Stuck keyE3Motor drive failureFLDoor failed to lock after 3 attempts.HrHeater Relay failureLEWater level sensor faultLODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15 minutes…nFNo FillodThe door has not been opened after two complete wash cyclesOEWater sensor level faultSrSystem Relay failureSuWasher is in suds periodtESump thermistor failure

Service modes (18)

  • Board Input TestWhile in Service Mode, press the Spin & Drain key
  • Board Output TestWhile in Service Mode, press the Spin Speed key.
  • Clear All Diagnostic CodesWhile viewing diagnostic codes in Service Mode, press Delay Start and Chime keys together for 3…
  • Clear Diagnostic Codes["While viewing diagnostic codes list, press Delay Start and Chime keys together for 3 seconds."]
  • Cycle CountWhile in Service Mode, press Soil Level
  • Cycle Count DisplayWhile in Service Mode, press Chime.
  • diagnosticRefer to the Technical Data Sheet shipped with the product for service mode diagnostics entry…
  • Diagnostic Code DisplayWhile in Service Mode, press Rinse & Spin key
  • Display Diagnostic Codes["Enter Service Mode.","Press Rinse & Spin key (display shows 'd').","Rotate Rotary Cycle Selector…
  • Display Software VersionWhile in Service Mode, press Soil Level
  • Fast Time Down / Advance to Next StepWhile any test or cycle is running in Service Mode, press the Temperature key to advance the…
  • Fast Time Down TestWhile any test or cycle is running in Service Mode, press the Wash/Rinse Temp key to advance the…
  • Hold Quick Service Cycle StepWhile Quick Service Cycle is running, press Rinse&Spin and Spin Only together.
  • Hold Quick Spin StepWhile Quick Spin Test is running, press the Rotary Selector key.
  • LED/Switch TestWhile in Service Mode, press the Delay Start key to start
  • Quick Service CycleWhile in Service Mode, press the Wash/Rinse Temp and Soil Level keys for 3 seconds
  • Quick Spin TestWhile in Service Mode, press Delay Start and Rinse & Spin keys.
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass