Maytag Washer Error Code 2E

The 2E error code means the voltage on the motor control bus is outside its acceptable range, either too high or too low. The washer's diagnostic system uses sub-codes to specify the condition: 91 indicates over-voltage and 92 indicates under-voltage. This fault stops the washer from operating normally to prevent damage to the motor and control components. The machine control board is the primary component involved.

No, you should not continue running the washer while the 2E error is active. An out-of-range motor control bus voltage indicates an electrical fault that could damage the motor, control boards, or other components if the machine is forced to operate. Stop use until the fault is diagnosed and repaired.

Resetting the washer may temporarily clear the 2E code from the display, but it will not fix the underlying electrical fault. If the machine control bus voltage is still out of range, the error will return as soon as the washer attempts to run. A proper repair addressing the root cause is required to resolve the error permanently.

A knowledgeable DIYer can address this error by first checking the wiring harness connections between the control boards and verifying the outlet voltage. However, the most likely fix is replacing the machine control board, which involves working with internal electrical components. If you are not comfortable disassembling the washer and handling control boards, a qualified appliance technician is recommended.

If the fix requires a new machine control board, parts alone typically range from around $100 to $250 depending on the specific model. Adding professional labor, total repair costs generally fall between $150 and $400. If the motor control unit or wash motor is also involved, costs can be higher.