mypros+
Model reference

Maytag MAH9700A

Washer

8 documents20 error codes9 service modes

Available documentation

Tech Sheet

  • 27" Front Load Washer - Technical Information14 pg
    Covers this model
  • 27" Front Load Washer⎯Technical Information16 pg
    Covers this model

Service Manual

  • Maytag Neptune 27" Front Load Washer L2005-00452 pg
    Covers this model

Service Flash

  • Service Pointer 8178646 Washer Recall2 pg
    Covers this model

Bulletin

  • Technical Bulletin - Washer Vibration/Walking/Noise on 27" Neptune washers6 pg
    Covers this model
  • Technical Bulletin - Vibration / Walking / Noise Reduction4 pg
    Covers this model

Training

  • Maytag Neptune 27" Front Load Washer52 pg
    Covers this model

Other

  • 160272058 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MAH9700A.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (20)

CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EOver current is detected; motor won't turn (motor failure).bEMotor tach signal exists without torque command or when not expected (abnormal…dcNever exceeded 400rpm due to an unbalanced load during final spin.dLOpen door lock switch with motor runningdSDoor switch is detected open and the door locked switch is read as locked…EWater sensor level faultE2Stuck key detectedE3Machine control is attempting to drive the motor but is not seeing any tach…FLDoor failed to lock after 3 attempts.HrHeater Relay failureLEWater level sensor faultLODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15 minutes…nFContinuous fill of 12 minutes or total fill of 14 minutes detected (no fill…odThe door has not been opened after two complete wash cycles; door switch was…OEA fault is detected in the water level sensorSrSystem Relay failureSudSWasher is in a suds period; excessive suds detected during the cycle.tEAbnormal high/low temperature or ohm resistance seen from sump thermistor.

Service modes (9)

  • Board Input TestWhile in Service Mode, press the Spin Only key.
  • Board Output TestWhile in Service Mode, press the Spin Speed key.
  • diagnosticRefer to the Technical Data Sheet shipped with the product for service mode diagnostics entry…
  • Diagnostic Code DisplayWhile in Service Mode, press Rinse&Spin key (display shows 'd'), then rotate Cycle Selector knob to…
  • Fast Time Down TestWhile any test or cycle is running in Service Mode, press the Temperature key to advance to next…
  • LED/Switch TestWhile in Service Mode, press the Delay key for 3 seconds.
  • Quick Service CycleWhile in Service Mode, press Temperature and Soil Level keys together for 3 seconds.
  • Quick Spin TestWhile in Service Mode, press Delay Start and Rinse&Spin keys together.
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass