mypros+
Model reference

Maytag NFW7200TW11

Washer

2 documents19 error codes10 service modes

Available documentation

Tech Sheet

  • Tech Sheet - DC68-02028G28 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion24 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag NFW7200TW11.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (19)

CodeMeaning
2EVoltage for motor control bus is over specified limit (diagnostic code 91) or…3EOver Current is detectedbEMotor tach signal exists without motor running or without torque commanded…dcNever exceeded 400 rpm due to an unbalanced load during final spin.dLOpen door lock switch with motor runningdSDoor switch is read as open and the door locked switch is read as locked.E2A key is sensed to be pressed more than 30 seconds; the key will be assumed to…E3Machine control is attempting to drive the motor but is not seeing any tach…FLDoor failed to lock after 3 attempts.HrHeater Relay Check signal not sensedLEWater sensor level faultLODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15 minutes…nFContinuous fill of 12 minutes or total fill of 14 minutes detectedodThe door has not been opened after two complete wash cyclesOEA fault is detected in the water level sensorSdWasher is in suds period; displays instead of remaining time.SrSystem Relay failuretEAbnormal high/low temperature or ohm resistance seen from sump thermistor.

Service modes (10)

  • Board Input TestWhile in Service Mode, press the Spin Only key
  • Board Output TestWhile in Service Mode, press the Spin Speed key.
  • Cycle Count DisplayWhile in Service Mode, press Chime.
  • Diagnostic Code DisplayWhile in Service Mode, press Rinse&Spin key
  • Display Software VersionWhile in Service Mode, press Soil Level
  • Fast Time Down / Advance to Next StepWhile any test or cycle is running in Service Mode, press the Temperature key to advance the…
  • LED/Switch TestWhile in Service Mode, press the Delay key for 3 seconds.
  • Quick Service CycleWhile in Service Mode, press Temperature and Soil Level keys for 3 seconds.
  • Quick Spin TestWhile in Service Mode, press Delay and Rinse&Spin keys.
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass