Model reference
Maytag MAH6700AW
Washer
8 documents17 error codes11 service modes
Available documentation
Service Manual
- 27" Front Load Washer Service Manual68 pg
- Maytag Neptune 27" Front Load Washer L2005-00452 pg
Bulletin
- Technical Bulletin - Drain hose leaks1 pg
- Technical Bulletin - Washer Vibration/Walking/Noise on 27" Neptune washers6 pg
- Technical Bulletin - Vibration / Walking / Noise Reduction4 pg
Training
- Maytag Neptune 27" Front Load Washer52 pg
Other
- Maytag Neptune MAH6700AW68 pg
- 160272058 pg
MyPros+ Max
Diagnose your Maytag MAH6700AW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (17)
CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EOver Current detectedbEMotor tach signal exists without motor running or when not expected.dcUnbalanced loaddLOpen door lock switch detected with motor running.dSDoor switch is read as open and the door locked switch is read as locked.E2Stuck keyE3Motor drive failureFLDoor failed to lock after 3 attempts.LEWater level sensor faultLODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15 minutes…nFNo FillodThe door has not been opened after two complete wash cyclesOEWater sensor level faultSrSystem Relay failuretESump thermistor failureService modes (11)
- Board Input TestWhile in Service Mode, press the Spin & Drain key
- Board Output TestWhile in Service Mode, press the Spin Speed key.
- Cycle Count DisplayWhile in Service Mode, press Chime.
- diagnosticRefer to the Technical Data Sheet shipped with the product for service mode diagnostics entry…
- Diagnostic Code DisplayWhile in Service Mode, press Rinse & Spin key
- Display Software VersionWhile in Service Mode, press Soil Level
- Fast Time Down TestWhile any test or cycle is running in Service Mode, press the Wash/Rinse Temp key to advance the…
- LED/Switch TestWhile in Service Mode, press the Delay Start key to start
- Quick Service CycleWhile in Service Mode, press the Wash/Rinse Temp and Soil Level keys for 3 seconds
- Quick Spin TestWhile in Service Mode, press Delay Start and Rinse & Spin keys.
- Service Mode1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass