Maytag Washer Error Code FCE2

FCE2 means the model and serial number information stored on the Main Control board does not match the information stored on the User Interface Control board. The washer compares this data between the two boards and flags a conflict when they do not agree. This is typically a configuration or programming issue rather than a mechanical failure. Accessing the Help Mode Sub Menu is the recommended first step to diagnose the mismatch.

An FCE2 code indicates a control configuration conflict, and the washer may not operate normally or at all while this fault is active. It is best to avoid running the machine until the issue is resolved to prevent incomplete cycles or unintended behavior. There is no immediate safety hazard to the home, but continuing to operate the washer in this state is not recommended.

If the fix only requires reprogramming an existing control board, the cost is primarily a service call fee, which typically ranges from around $75 to $150 depending on your location. If a control board needs to be replaced, parts and labor combined can range from $150 to $400 or more depending on which board is faulty and local labor rates. Getting a diagnostic assessment first will clarify whether reprogramming or part replacement is needed.

Start by entering the Help Mode Sub Menu programming on the washer to review the model and serial number stored on each control board. If the data is missing or incorrect on one board, it may need to be reprogrammed with the correct information. If a control board was recently replaced, ensure it is the correct part for your model and that it has been properly configured. A control board that cannot retain its programming will need to be replaced.

A simple power reset is unlikely to permanently clear the FCE2 code because the fault is caused by a persistent data mismatch stored in the control boards, not a temporary glitch. The code will typically return after the reset if the underlying programming conflict is not corrected. Resolving FCE2 requires checking and correcting the model and serial number data through the Help Mode Sub Menu.