Maytag Washer Error Code 8

Error code 8 on a Maytag washer indicates a water level sensor fault. The control board has detected that the input signal from the water level sensor is outside its acceptable range. The washer displays 'LE', beeps, and pauses the wash cycle until the issue is resolved.

You should not continue running the washer while error code 8 is active. The washer pauses the cycle because it cannot confirm the correct water level, which means it may run with too little or too much water and could damage clothing or the machine. Address the fault before resuming normal use.

Repair costs depend on the failed component. A replacement water level sensor or pressure switch typically costs between $15 and $60 for the part alone. If a professional technician is needed, expect to pay between $100 and $250 or more depending on your location and the extent of the repair, especially if the control board is involved.

Some causes of error code 8 are DIY-friendly. Start by checking that your water supply valves are fully open and the inlet hoses are not kinked. Then inspect the small pressure hose connected to the water level sensor for kinks, cracks, or loose connections. If those steps do not resolve the fault, testing or replacing the water level sensor is a moderate repair that many experienced DIYers can handle with basic tools.

A reset may temporarily clear the error code display, but if the underlying fault with the water level sensor, pressure hose, wiring, or water supply is still present, the code will return during the next cycle. A reset alone is not a fix and the root cause needs to be diagnosed and corrected.