mypros+
Model reference

Maytag FAV7500A

Washer

2 documents21 error codes8 service modes

Available documentation

Tech Sheet

  • Top Load Washer Technical Information14 pg
    Covers this model
  • Tech Sheet - 16023174_1602317414 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag FAV7500A.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (21)

CodeMeaning
1No Drain10Unbalance or cabinet hit detected during final spin prevented the spinner from…11Will not remember machine settings15Stuck Key16High speed not achieved due to torque17The lid was not opened after the last three completed wash cycles.18Detected lid lock switch open during cycle when not expected (open lid lock…2Lid failed to unlock after multiple attempts.22Detected lid sensor switch open and lid locked switch locked during cycle when…23Lid is locked at start of cycle24Motor high RPM detected two times25Tach signal exists without torque input (abnormal condition)28Water valve thermistor failure3No Fill34Welded system relay4Lid failed to lock after 11 attempts.40Load bound up5Continuous unbalanced loads during spin only; out of balance circuit triggered.6Locked rotor forcing a shut down; rotor is still locked after 10 attempts.8Water level sensor faultLEWater level sensor fault

Service modes (8)

  • Display Diagnostic CodesEnter Service Mode
  • Quick Spin TestEnter Service Mode, then select the Quick Spin Test option on screen.
  • Service CycleEnter Service Mode, then select Service Cycle option on screen.
  • Service ModePress the Help and Back keys simultaneously for three seconds or until the control beeps.
  • System CheckEnter Service Mode, then select the desired output to test on the display
  • System Check (Board Output Test)Enter Service Mode, then select System Check on screen
  • Tub Displacement Sensor Diagnostics1) Enter Service Mode by pressing Help and Back keys for three seconds
  • User Interface TestEnter Service Mode, then select User Interface option and follow on-screen directions.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax