Maytag Washer Error Code d14/F33

The d14/F33 code means the washer's Central Control Unit has lost its electrical connection to the drain pump. The CCU monitors the pump circuit continuously, and this fault triggers when that signal is interrupted. It does not always mean the pump has failed; a loose or corroded wiring connector is a very common cause. Checking the electrical connection at the DP2 connector is the recommended first diagnostic step.

Clearing the error code is the correct first step, but the code will return if the underlying wiring or connection issue has not been resolved. A reset alone is not a fix. The electrical connection between the pump and the CCU must be inspected and confirmed solid for the repair to hold.

The cost depends on what component is at fault. If the fix is simply reseating a loose connector, there may be no parts cost, though a service call could run anywhere from $75 to $150 for labor. A replacement drain pump typically costs between $40 and $120 for the part, while a new CCU board can range from $150 to $350 or more depending on the model. Getting a diagnostic visit first can help avoid replacing parts unnecessarily.

In many cases, yes. Start by unplugging the washer, locating the wiring connector between the drain pump and the CCU (labeled DP2), and firmly reseating it. If the connector looks corroded or damaged, that will need to be addressed before the error clears. More advanced repairs like replacing the pump or CCU board are better suited for technicians with electrical diagnostic experience.

You should not continue running the washer while this fault is active. Without a confirmed connection to the drain pump, the washer cannot reliably drain water, which could lead to incomplete cycles or water remaining in the drum. Unplug the unit and inspect the wiring before attempting another wash cycle.