Model reference

Samsung DW-KG86AA

Dishwasher

1 document19 error codes5 service modes

Available documentation

Service Manual

Samsung DW80K5050US AA Dishwasher Service Manual64 pg
Covers this model

MyPros+ Max

Diagnose your Samsung DW-KG86AA.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (19)

CodeMeaning

3CCirculation pump failure 4CWater supply failure 4C5200 water supply pulses detected during non-water supply mode.5CDishwasher is not draining 7CVane/distributor motor position sensing failure 9C1Blackout or DC Link voltage high or low voltage condition detected 9C2Blackout or DC Link voltage high or low voltage condition detected ACCommunications between the main PBA and the sub PBA fails for 24 seconds (6…AC6No response received from inverter PBA for 3 seconds; inverter relay off for 2…bC2Touch button pressed and held for 30 continuous seconds or longer.bC3IC communications between the Sub PBA and the touch button fails.dC3Auto Door Open device operates but door opening is not sensed after 3 retries.FCFan motor RPM measured less than 3000 RPM after 6 retries.HCTemperature measured as equal to or greater than 80°C for 3 seconds HC1Heater not heating properly LCWater leakage sensor data is equal to or less than 3V for 3 seconds.OCOverflow sensor data is equal to or less than 3V for 5 seconds.PCDistributor synchronous motor position not detected for 2 minutes after…tCTemperature sensor data output is equal to or greater than approximately 4.5V…

Service modes (5)

Information Display Mode["While 'AS' displays, press Hi-Temp Wash Key to cycle through information
LED or Input Key Check["Push Hi-Temp Wash + Sanitize + Power Key
Smart Install Auto Mode["Enable Smart Install Mode","Displays 'AS' before Auto Mode is enabled","Press Start Key to…
Smart Install Manual Mode["Enable Smart Install Mode","Each time Auto Key is pressed, the Manual Mode step changes…
Smart Install Mode - Enable["Set the timer for 1h with Power On","Press Hi-Temp Wash Key for at least 3 seconds"]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax