mypros+
Model reference

Samsung DW80R5060US/AA-00

Dishwasher

3 documents21 error codes7 service modes

Available documentation

Service Manual

  • Dishwasher Service Manual66 pg
    Covers this model
  • DISHWASHER SERVICE Manual40 pg
    Covers this model

Other

  • LG Samsung Dishwasher No Power R5060 SVC Tip 05 7 2020ptx12 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung DW80R5060US/AA-00.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (21)

CodeMeaning
1CLow water level anomaly detected 3 times during a wash stage after HC condition…3CBLDC circulation pump error with sub-codes L1-L6, L8, and Ld covering…4CWater supply error4C5200 water supply pulses detected during non-water supply mode; repeats water…5CDrain pump error occurred 4 times; if water level remains high after draining…5C6BLDC C-pump error with sub-codes C1 (phase current over 2A after 5 restarts)…7CVane motor position sensing failure9C1DC Link voltage is high or low voltage condition (blackout or abnormal…9C2DC Link voltage is high or low voltage condition (blackout or abnormal…ACCommunication between main PBA and sub PBA is abnormal; buzzer and drain will…AC6No response received from inverter PBA for 3 seconds; inverter relay off for 2…bC2A button is pressed and held for 30 continuous seconds or longer.bC3IC communications between the Sub PBA and the touch button has failed.dC3Auto Door Open device operates but door opening is not sensed after 3 retry…FCFan motor RPM measured less than 3000rpm after 6 retry attempts.HCHigh temperature heating errorHC1Heater not heating properlyLCLeakage errorOCOverflow sensor data is equal to or less than 3V for 5 seconds; retries 3 times…PCDistributor motor position errortCThermistor short circuit or open circuit detected; heater is turned off and…

Service modes (7)

  • Information Display Mode["While 'AS' displays, each time Hi-Temp Wash Key is pressed, display changes in the following order
  • LED/Input Key Test["Push 'Hi-Temp Wash' + 'Sanitize' + 'Power Key'
  • Smart Install Auto Mode["Enable Smart Install Mode (set timer for 1hr, press Hi-Temp Wash Key for 7+ seconds).","Display…
  • Smart Install Manual Mode["Enable Smart Install Mode.","Each time Auto Key is pressed, the Manual Mode step changes…
  • Smart Install Mode - Enable["Set the timer for 1 hour with Power On.","Press Hi-Temp Wash Key for at least 7 seconds."]
  • Smart Install Mode (Auto Mode)["Power on the dishwasher.","Set the timer to 17 hours.","Press and hold the Hi-Temp Wash key for…
  • Smart Install Mode (Manual Mode)["Enable Smart Install Mode (set timer to 17h with Power On, press Hi-Temp Wash key for 7+…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax