Model reference

Whirlpool GU3600XTSY2

Dishwasher

12 documents19 error codes5 service modes

Available documentation

Tech Sheet

Whirlpool Dishwasher Gu3600xtvb2 Tech Sheet W101428262 pg
Covers this model
Tech Sheet - W10130990 - Rev C2 pg
Covers this model
Whirlpool Dishwasher DU1300XTVB1 Tech Sheet W101309902 pg
Covers this model
Kitchenaid Dishwasher KUDL03FVSS0 Tech Sheet2 pg
Covers this model

Service Flash

Service Pointer 8178580 Dishwasher Door Hard to Close4 pg
Covers this model

Tech Tip

quickreferenceinsertsheet-w10164331-reva-sp.pdf1 pg
Covers this model
Instruction sheet - W10202871 - Rev C3 pg
Covers this model
Installation Instructions6 pg
Covers this model

Installation Guide

Installation Instructions32 pg
Covers this model
Instruction Sheet4 pg
Covers this model
Instruction Sheet2 pg
Covers this model

Other

K43174826 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GU3600XTSY2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool GU3600XTSY2

M+

Pilot relay (K2) stuck on/closed -

From Tech Sheet W11818473, p.45:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (19)

CodeMeaning

1-1Pilot relay (K2) stuck on/closed 2-1Stuck key detected in keypad or keypad connection.2-2User Interface cannot communicate with main control (no response).3-1Thermistor/OWI temperature sensing circuit open 3-2Thermistor/OWI temperature sensing circuit shorted 3-3OWI (optical soil sensor) failed calibration.4-1Diverter cannot find position 4-4Diverter motor is stuck ON.5-1Door switch 5-2Door switch not opening between cycles 5-5Diverter disk in sump is missing.6-1Wash motor 6-2Wash motor 7-1Heating 7-2Heating element stuck ON.8-1Inlet water 8-2Inlet water 8-3Inlet water 9-1Draining

Service modes (5)

Control Lock TogglePress and hold the Heated Dry key for 5 seconds to turn off (or on) the Control Lock feature.
Sales Demo Mode TogglePress the following key sequence in less than 3 seconds
Service Diagnostics WITH Error CodesPress Heated Dry, Normal, Heated Dry, Normal, Heated Dry, Normal in sequence within 6 seconds while…
Service Diagnostics WITHOUT Error CodesPress Heated Dry, Normal, Heated Dry, Normal in sequence within 6 seconds while in standby mode
Stuck Key Test1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass