Model reference

Whirlpool IDT870SAGX0

Dishwasher

1 document31 error codes1 service mode

Available documentation

Tech Sheet

Tech Sheet - W11266095 - Rev A16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool IDT870SAGX0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool IDT870SAGX0

M+

Control detected K400 pilot relay stuck

From Tech Sheet W18569905, p.37:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (31)

CodeMeaning

1-1Control detected K400 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem 10-2Vent wax motor electrical problem (not all models)10-3Drying fan error (on models with fan)12-1No communication between ECM and control 12-2No link between ECM and wireless router 12-3No link between ECM and Internet 12-5Antenna B problem 12-7Provisioning problem 2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control 3-1Open connector or component in Temperature Sensing circuit 3-2Incoming water temperature above 167°F (75°C), or shorted connection/component…3-3OWI calibration failure 4-4Wash motor failure 5-1Door stuck open 5-2Door stuck closed 6-1Low/no water (mechanical problem)6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Float switch open 6-7Disconnected or damaged flowmeter.6-8Water softener regeneration valve electrical problem (water softener models…7-1No heat 7-2Heater stuck on 8-4Drain motor electrical problem 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disc missing

View all 31 error codes

9-4Lower spray arm error

Service modes (1)

Service Diagnostics Cycle["Ensure dishwasher is in Standby mode.","Press START/RESUME to wake up control panel.","Press any…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass