Model reference

Whirlpool W10610059B

Dishwasher

1 document28 error codes4 service modes

Available documentation

Tech Sheet

Tech Sheet W1061005912 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10610059B.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool W10610059B

M+

Control detected K2 pilot relay stuck

From Tech Sheet W10825067, p.39:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (28)

CodeMeaning

1-1Control detected K2 pilot relay stuck closed.1-2Damaged or corrupted memory or control board, incompatible software components…10-1Dispenser electrical problem; loose connection in Dispenser circuit and/or open…10-3Drying fan error; loose connection in fan circuit, and/or open fan motor.2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control; loose user interface…3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Shorted connection or component in Temperature Sensing circuit; incoming water…3-3OWI calibration failure.4-3Wash motor not running due to loose connection in Motor circuit and/or faulty…5-1Door stuck open; loose connection in Door Switch circuit and/or door switch…5-2Door stuck closed; control programmed to not start if it suspects the door…6-1Inlet water low/no water mechanical problem; no water to dishwasher.6-2Inlet water fill valve electrical problem; loose connection in Fill Valve…6-3Suds/air in pump; too many suds, bowls capturing wash water, water leaking, or…6-4Float switch open; overfill switch stuck in Overfill position and/or dishwasher…6-6Incoming water cool; water under 84°F (29°C).6-8Regeneration valve electrical problem; loose connection in Regen valve circuit…7-1No heat; control programmed to disable heater if it detects a water heating…7-1 (flowmeter)Disconnected or damaged flowmeter.7-2Heater stuck on; Heater Drive circuit on the control is faulty.8-1Slow drain; obstructed drain hose or path.8-2Drain motor electrical problem; loose connection in Drain Motor circuit and/or…8-3Drain motor stuck on 8-5Drain motor stuck on; Drain Motor Drive circuit on the control is faulty.9-1Diverter can't find position; corroded or loose connection in diverter…9-2Diverter stuck on; Diverter Drive Circuit on the control is faulty.9-3Diverter disk missing from sump.

Service modes (4)

Clear Customer Error History["Enter Service Diagnostics Cycle.","Advance to interval 22 (Hi Temp LED will be on).","Press Hi…
Customer Cycle Rapid AdvanceAfter starting a customer cycle, press HIGH TEMP
Rapid Advance Mode (Customer Cycles)["Start a customer cycle.","Press HIGH TEMP
Service Diagnostics Cycle["Press Start key to wake up the control panel.","Press any 3 keys in the sequence…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass