Model reference

Whirlpool W11349311A

Name: Whirlpool W11349311A
Brand: Whirlpool

Dishwasher

1 document26 error codes2 service modes

Available documentation

Tech Sheet

Tech Sheet - W11349311 - Rev A26 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W11349311A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool W11349311A

M+

Control detected K2 pilot relay stuck

From Tech Sheet W17241353, p.45:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

1-1Control detected K2 pilot relay stuck closed.1-2Damaged or corrupted memory or control board; incompatible software components…10-1Dispenser electrical problem; loose connection in dispenser circuit and/or open…10-3Drying fan error; loose connection in fan circuit and/or open fan motor, or fan…2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control; loose user interface…3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Shorted connection or component in Temperature Sensing circuit; shorted or…3-3OWI calibration failure; OWI failure or drain hose check valve not sealing.4-3Wash motor not running; loose connection in motor circuit and/or faulty wash…5-1Door stuck open; door was not latched within 4 seconds of pressing Start/Resume…5-2Door stuck closed; control programmed to not start if it suspects door switch…6-1Inlet water low/no water (mechanical problem); no water to dishwasher, captured…6-2Fill valve electrical problem; loose connection in fill valve circuit and/or…6-3Suds/air in pump; too many suds, bowls capturing wash water, water leaking, or…6-4Float switch open; overfill switch stuck in overfill position and/or dishwasher…6-7Flowmeter disconnected or damaged.6-8Regen valve electrical problem; loose connection in Regen valve circuit, and/or…7-1No heat; control programmed to disable heater due to detected water heating…7-2Heater stuck on; Heater Drive circuit on the control is shorted.8-1Slow drain; obstructed drain hose or path, or drain pump impeller fractured.8-2Drain motor electrical problem; loose connection in drain motor circuit and/or…8-3Drain stuck on; drain motor drive circuit on the control is shorted.9-1Diverter can't find position; corroded or loose connection in diverter…9-2Diverter stuck on; diverter drive circuit on the control is shorted.9-3Control detected diverter disk in sump is missing.

Service modes (2)

Rapid Advance (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Service Diagnostics CycleWhile in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass