Model reference

Whirlpool WDF520PADW5

Dishwasher

9 documents19 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet16 pg
Covers this model
Tech Sheet12 pg
Covers this model
Fiche technique W10849768A16 pg
Covers this model
Fiche technique - Tech Sheet W1084976816 pg
Covers this model
Tech Sheet12 pg
Covers this model

Tech Tip

Instruction Sheet2 pg
Covers this model

Quick Reference

Manual de referencia rápida1 pg
Covers this model

Other

W10590888 - Rev C (fr)16 pg
Covers this model

Installation Guide

Installation Instructions Undercounter Dishwasher Plastic Tub76 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WDF520PADW5.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool WDF520PADW5

M+

Control detected K1 pilot relay stuck

From Tech Sheet W15174929, p.21:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (19)

CodeMeaning

1-1Control detected K1 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem 2-1Control detected stuck key(s) in keypad or keypad connection; stuck key will be…3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Incoming water temperature above 167°F (75°C), or shorted connection/component…3-3OWI calibration failure, or drain hose check valve not sealing allowing dirty…4-3Wash motor not running due to loose connection in Motor circuit, faulty wash…5-1Door stuck open 5-2Door stuck closed 6-1Low or no water (mechanical problem)6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Float switch open 7-1No heat 7-2Heater stuck on 8-1Slow drain 8-2Drain motor electrical problem 8-3Drain stuck on

Service modes (3)

Error Code ReadingEnter Service Diagnostics (1-2-3-1-2-3-1-2-3). Interval 25
Rapid Advance (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Service Diagnostics CycleWith dishwasher in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass