Model reference

Whirlpool WDT995SAFM0

Dishwasher

4 documents26 error codes4 service modes

Available documentation

Tech Sheet

Wiring Diagram - W10887393 - Rev A2 pg
Covers this model
Tech Sheet - W10887603 - Rev A (FR)16 pg
Covers this model
Tech Sheet - W10837602 - Rev A_W1083760212 pg
Covers this model

Tech Tip

Instruction Sheet2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WDT995SAFM0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dishwasher

1-1 on my Whirlpool WDT995SAFM0

M+

Control detected K1 pilot relay stuck

From Tech Sheet W15049509, p.41:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

1-1Control detected K1 pilot relay stuck closed.1-2Damaged or corrupted memory on control board or incompatible software…10-1Dispenser electrical problem 12-1No communication between ECM and control 12-2No link between ECM and wireless router 12-3No link between ECM and Internet 12-5Antenna B problem 12-7Provisioning problem 2-2User interface cannot communicate with main control; loose user interface…3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Incoming water temperature above 167°F (75°C), shorted connection or component…3-3OWI failed calibration, or drain hose check valve not sealing allowing dirty…4-3Wash motor not running due to loose connection in Motor circuit, faulty wash…5-1Door stuck open 5-2Door stuck closed 6-1Low/no water 6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Float switch open 7-1No heat 7-2Heater stuck on 8-2Drain motor electrical problem 8-3Drain stuck on 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disc missing

Service modes (4)

Customer Program Fast Advance ModeAfter starting a customer program, press HI TEMP
Rapid Advance (Customer Cycle)After starting a customer cycle, press HIGH TEMP
Service Diagnostic ProgramWith appliance idle, press any 3 keys in sequence 1-2-3-1-2-3-1-2-3 with less than one second…
Service Diagnostics CycleWhile in Standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass