Model reference
Whirlpool RBD305PDQ3
Oven
8 documents33 error codes11 service modes
Available documentation
Tech Sheet
- Tech Sheet - 4454767 - Rev B8 pg
- TECH SHEET - Whirlpool Oven RBD305PDB66 pg
- Whirlpool Oven RBD305PDB4 Tech Sheet8 pg
- TECH SHEET - Whirlpool Oven RBD305PDB96 pg
Service Manual
- Kitchenaid Whirlpool Built In Single Double Electric Wall Ovens D Models Service Manual146 pg
- Service Manual 4317164 bochniak146 pg
Installation Guide
- Installation Instructions5 pg
Other
- servicemanual 4317164.pdf146 pg
MyPros+ Max
Diagnose your Whirlpool RBD305PDQ3.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (33)
CodeMeaning
E1Electronic control assembly failure.E2Keypad not connected.E3Keypad not connected, key held down too long, or key is shorted.F0Default F codeF0-E0Default F codeF0-E3Wiring harness cavity size does not match previously stored valueF1Default F-CodeF1-E0Electronic control malfunction.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6Key held down too long, or key is shorted.F2Keypad is not connected, keypad held too long, or keypad is shorted.F2-E0Temperature sensor opened.F2-E1Temperature sensor shorted.F2-E2Keypad not connected.F2-E3Key held down too long, or key is shorted.F3Wiring harness cavity size does not match the previously stored value (cavity…F3-E0Temperature sensor opened (open circuit).F3-E1Temperature sensor shorted.F4Temperature sensor open.F4-E0Meat probe malfunctionF5Temperature sensor shorted or oven temperature is too high (runaway)F5-E0Door is open, but latch is locked (door switch indicates open door and latch…F5-E1Self-clean latch will not lock.F5-E5Self-clean temperature 288°C (550°F) not reached within 45 minutes.F5-E6Door is open, but latch is locked.F5-E7Self-clean latch will not unlock.F6Shorted meat probe or miswired temp probe.F7Oven door latch will not lock.F7-E1Common switch wire (+5VDC) to latch switch and door switch is shorted to…Service modes (11)
- Bake temperature offset adjustment1
- Default F code display (no failure diagnostic)Press and hold CANCEL key for 5 seconds
- Default F code display (no failure)Press and hold CANCEL key for 5 seconds
- Fahrenheit to Celsius conversionPress the BROIL pad for 5 seconds
- Fahrenheit to Celsius display changePress the BROIL keypad for 5 seconds
- Fault Code Display["Press and hold CANCEL key for 5 seconds.","If no pre-existing fault, F0-E0 will be displayed."]
- Fault Code Display (No Pre-existing Fault)["Press and hold UPPER OFF key for 5 seconds
- Oven temperature calibrationTouch and hold the BAKE keypad for 5 seconds. The display will indicate the present oven…
- Programming the Cavity Size["Within 60 seconds of power up, press the following touchpads in order
- Sabbath mode - Double oven1
- Sabbath mode - Single oven1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass