mypros+
Model reference

Whirlpool RBS277PVQ03

Oven

6 documents22 error codes6 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10343435 - Rev A16 pg
    Covers this model

Service Flash

  • Service Pointer - PF Error Code and/or Slow Running Clock5 pg
    Covers this model

Tech Tip

  • Instruction Sheet1 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
  • Installation Instructions8 pg
    Covers this model
  • Instruction Sheet1 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool RBS277PVQ03.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0No error(s) foundF1Electronic control malfunction (applies to all E codes under F1).F2 E0Key held down too long, or key is shorted.F2 E1Keypad keytail not connected.F2 E5Cancel key drive line open.F2 E6Cancel key drive line open.F2-E0Key held down too long, or key is shorted.F2-E1Keypad keytail not connected.F2-E5Cancel key drive line open.F2-E6Cancel key drive line open.F3 E0Temperature sensor opened (R=2875 ohms by spec).F3 E1Temperature sensor shorted (R=825 ohms by spec).F3 E2Oven temperature too high, over 575°F (302°C) in Cook mode.F3 E3Oven temperature too high, over 950°F (510°C) in Clean mode.F3-E0Temperature sensor opened (R=2875Ω by spec).F3-E1Temperature sensor shorted (R=825Ω by spec).F3-E2Oven temperature too high, over 575°F (302°C) in Cook mode.F3-E3Oven temperature too high, over 950°F (510°C) in Clean mode.F5 E0Door is opened but latch is locked; door switch is open indicating open door…F5 E1Self-Clean latch will not lock/unlock.F5-E0Door is opened but latch is lockedF5-E1Self-Clean latch will not lock/unlock.

Service modes (6)

  • Bake Temperature Offset AdjustmentPress and hold BAKE for 5 seconds
  • Cavity Size Programming (Self-Clean Models)Within 60 seconds of power up, press the following keypads in sequence
  • Cavity Size Programming (Standard-Clean Models)Within 60 seconds of power up, press the following keypads in sequence
  • Error Code RetrievalPress and hold CANCEL key for 5 seconds.
  • Fahrenheit/Celsius TogglePress and hold BROIL for 5 seconds to toggle temperature between Fahrenheit and Celsius settings.
  • Fault Code DisplayPress and hold CANCEL key for 5 seconds.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass