mypros+
Model reference

Whirlpool WFE710H0AE1

Range

7 documents13 error codes12 service modes

Available documentation

Tech Sheet

  • WFE710H0AS0 Tech Sheet W10392960 Rev A8 pg
    Covers this model

Service Manual

  • Dimension Guide1 pg
    Covers this model
  • Dimension Guide1 pg
    Covers this model

Tech Tip

  • Oven Cleaning Quick Reference Guide2 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFE710H0AE1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (13)

CodeMeaning
F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7PCB thermistor open or shorted.F2-E0Keypad disconnected.F2-E1Stuck key.F2-E2Cancel key error.F3-E0Main oven sensor open or shorted.F3-E2Warming drawer sensor open or shorted.F5-E0Door and door position switches do not agree.F5-E1Door latch not operating (Clean mode—on some models).F6-E1Over temperature during cook mode.F6-E2Over temperature during clean mode.F6-E3Over temperature (warming drawer).

Service modes (12)

  • Auto TestEnter Diagnostics Mode (CANCEL > CANCEL > START), then press the up arrow, '+' key, or '3' key to…
  • CONTROL RESETEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 6 'CONTROL RESET'.
  • Diagnostics Mode (MRC Control)Press CANCEL > CANCEL > START
  • DISPLAYEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 5 'DISPLAY'.
  • ENG MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 2 'ENG MODE'
  • FAULTSEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 7 'FAULTS'.
  • RELAY USAGEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 8 'RELAY USAGE'.
  • Temperature Adjustment1
  • TEST MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 3 'TEST MODE'
  • TEST ON (Relay Checks)Upon entry into Diagnostics Mode (CANCEL > CANCEL > START), the display shows 'TEST ON'
  • USAGEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 1 'USAGE'.
  • VERSIONEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 4 'VERSION'.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass