mypros+
Model reference

Whirlpool YWFE710H0BH0

Range

6 documents13 error codes15 service modes

Available documentation

Tech Sheet

  • Fiche technique - Tech Sheet W104416338 pg
    Covers this model
  • WFE710H0AS0 Tech Sheet W10392960 Rev A8 pg
    Covers this model

Tech Tip

  • Oven Cleaning Quick Reference Guide2 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool YWFE710H0BH0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (13)

CodeMeaning
F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7Circuit board thermistor open or short-circuited.F2-E0Keypad disconnected.F2-E1Stuck key.F2-E2Cancel key error.F3-E0Main oven temperature sensor open or short-circuited.F3-E2Oven temperature sensor open or short-circuited (secondary).F5-E0Door and switch mismatch during clean mode.F5-E1Door latch not functional during clean mode.F6-E1Bake mode excessive temperature (runaway).F6-E2Clean mode excessive temperature (runaway).F6-E3Warming drawer excessive temperature (runaway).

Service modes (15)

  • Auto TestFrom Service Mode (TEST ON), press up arrow, '+', or '3' to scroll to AUTO TEST
  • CONTROL RESETFrom Service Mode, scroll to CONTROL RESET.
  • Diagnostics Mode (MRC Control)Press CANCEL > CANCEL > START
  • DISPLAYFrom Service Mode, scroll to DISPLAY.
  • ENG MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode step 2 'ENG MODE'
  • ENG MODE (Engineering Mode)From Service Mode, scroll to ENG MODE
  • FAULTSFrom Service Mode, scroll to FAULTS.
  • MRC Control Module Diagnostic Mode (Service Mode)Press CANCEL > CANCEL > START
  • RELAY USAGEFrom Service Mode, scroll to RELAY USAGE.
  • Temperature Adjustment1
  • TEST MODEFrom Service Mode, scroll to TEST MODE
  • TEST ON (Relay Checks)Upon entry into Diagnostics Mode (CANCEL > CANCEL > START), the display shows 'TEST ON'
  • TEST ON (Relay Test Mode)Upon entering service mode (CANCEL>CANCEL>START), TEST ON is displayed
  • USAGEFrom Service Mode, scroll to step 1 (USAGE) using up/down arrows.
  • VERSIONFrom Service Mode, scroll to VERSION.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass