mypros+
Model reference

Whirlpool 46462500

Washer

1 document16 error codes3 service modes

Available documentation

Tech Sheet

  • Kenmore Whirlpool Washer 110 46462500 Tech Sheet16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool 46462500.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (16)

CodeMeaning
F/01EEPROM communication error between the Central Control Unit (CCU) and the…F/11Motor Control Unit (MCU) has internal failure; repeating under or over voltage…F/20No water detected entering machine or pressure switch trip not detected…F/21Long drain error; drain time exceeds 8 minutes and water valves turn off.F/22Door lock error; after 6 failed attempts to lock the door.F/24Water temperature sensor (NTC) error; value is out of range (-5°C to 103°C)…F/25Drive motor tachometer error; control is unable to properly detect motor speed…F/26Door switch error; door has not been opened for 3 consecutive cycles or door…F/27Overflow condition; overflow contact on the pressure switch is closed for more…F/28Serial communication error; communication between the CCU and MCU cannot be…F/29Door unlock error; door unlock has failed 6 times.F/30Dispenser system error; dispenser motor cannot be driven to its proper position.F/31MCU failure; thermal protector on the MCU heat sink gets too hot, stopping…F/33Pump drive system error; connection between pump and the Central Control Unit…F/34Clothes still inside drum during the Cleaning Washer Cycle; load detected…SdSuds lock

Service modes (3)

  • Manual Diagnostic Test["Washer must be empty and control must be in OFF state.","Close the door.","Press and hold any key…
  • Quick Entry Diagnostic Test (bypasses Service History)["Execute with an empty drum.","Close the door.","Push CONTROL/ON.","Select the DRAIN/SPIN…
  • Service History Mode & Diagnostic Test (Universal)["Washer must be empty and control must be in OFF state.","Close the door.","Press and hold any key…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax