mypros+
Model reference

Whirlpool WTW5010LW1

Washer

5 documents34 error codes5 service modes

Available documentation

Service Manual

  • Dimension Guide12 pg
    Covers this model

Tech Sheet

  • Tech Sheet - W11428598 - Rev D2 pg
    Covers this model

Service Flash

  • Service Pointer - W11618678 - Rev A - Top Load Washers Cycle Won't Start3 pg
    Covers this model
  • Technical Service Pointer #W11750573 Rev. B - Vertical Drain Pump Not Draining8 pg
    Covers this model

Quick Reference

  • Quick Start Guide2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WTW5010LW1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (34)

CodeMeaning
F0E2Oversuds condition detected.F0E3Overload condition detected.F0E4Spin limited by water temperature.F0E5Off balance load detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ring condition.F0E9Off balance pause condition.F1E1Main Control (ACU) fault.F1E2Motor drive module over voltage.F2E1UI stuck button detected.F2E2UI disconnected from the control.F2E3ACU/UI mismatch detected.F3E2Pressure system fault.F3E3Inlet water temperature fault.F5E1Lid switch faultF5E3Lid will not lock or unlock.F5E4Lid not opened between cycles.F6E1Communication errorF6E3Communication errorF7E1Tachometer missing or wrong signal.F7E2MCI drive failure.F7E3Basket engaged during wash.F7E4Basket re-engagement failure.F7E6Motor circuit open.F7E7Motor unable to reach target RPM.F7E8Motor drive module over temperature.F7E9Locked rotor condition.F7EAMotor phase loss.F7ECMotor drive module over current/overload.F8E1Long fill condition.
View all 34 error codes
F8E3Overflow or flood condition.F8E6Water hazard condition.F9E1Long drain fault.F9E9Wrong voltage detected.

Service modes (5)

  • Automatic Test["Enter Service Mode.","Press Key 2 and then Key 5."]
  • Fault History["Enter Service Mode.","Press Key 3."]
  • Service Mode Entry["Ensure washer is in standby mode (plugged in with all LEDs off).","Within 8 seconds, press and…
  • Software Version["Enter Service Mode.","Press Key 2 for 3 seconds."]
  • UI Test["Enter Service Mode.","Press Key 1."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass