ASKO Washer Error Code F2

F2 on an Asko washer indicates a wash motor fault. The code is triggered by one of three conditions: an interruption in the cables connected to the motor, a loss of power to the motor, or a mechanical lockup of the motor. The machine halts the cycle to prevent further damage until the fault is resolved.

Turning off the main switch to reset the machine may clear the F2 code temporarily, but it will return if the underlying fault is not corrected. A reset is useful as a first step to rule out a transient glitch, but any recurring F2 code requires physical inspection of the motor and its wiring.

Repair costs vary depending on the root cause. A simple wiring fix or connector replacement may cost relatively little in parts, while a full motor replacement on an Asko washer can range from a few hundred dollars to over five hundred dollars including labor. Getting a diagnostic assessment from a technician before committing to a repair is recommended.

Some causes of F2 are DIY-friendly, such as reseating a loose connector or inspecting visible wiring for damage. However, diagnosing a failed motor, checking voltage at the motor terminals, or replacing worn bearings typically requires electrical knowledge and comfort working around appliance components. If you are unsure, a qualified technician should perform the hands-on diagnosis.

No, you should not continue running the washer while F2 is active. The motor is either not operating correctly or cannot operate at all, and forcing the machine through a cycle risks damaging the motor further or causing overheating. Power the machine off and diagnose the fault before resuming use.