ASKO Washer Error Code F7

F7 indicates that the Asko washer detected excessive foaming after the main wash phase. The machine checks suds levels at this point in the cycle and displays the code at the end of the program if foam is too high. This is not a mechanical fault but a usage-related alert. It is not available on all Asko models.

A reset may clear the displayed code temporarily, but F7 will return if the underlying cause, excess or unsuitable detergent, is not addressed. The recommended approach is to run a rinse cycle first, then correct your detergent type and dosage before starting the next wash program. This ensures the machine completes its post-wash foam check without triggering the fault again.

In most cases, fixing F7 costs nothing beyond switching to a different detergent and adjusting your dosage. If a service technician is needed to diagnose persistent foaming issues or clean internal components, expect a typical service call to range from $75 to $150 depending on your location. No parts replacement is generally required for this error code.

Start by running a rinse-only program to flush excess suds from the machine. After that, reduce the amount of detergent you are using and switch to a low-lather or HE-rated washing powder. Also clean the dispenser drawer and drum interior to remove any residual detergent buildup that could cause the issue to repeat.

F7 is not a safety hazard. It is a usage alert that indicates too much foam was produced during the wash cycle. The machine completes the program before displaying the code, so there is no immediate risk to the appliance or your laundry. Correcting detergent use promptly will prevent repeated triggering of the code and reduce stress on the pump system over time.