mypros+
Error code reference

ASKO Washer Error Code F8

Control card fault-A fault has occurred on the control card, which must be replaced to ensure complete safety

ASKO codesASKO washer codes
Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the F8 error code actually means

Your Asko washer has detected an internal problem with its main electronic control board, which is the brain of the machine. The washer is designed to stop operating and flash a warning on the display when this happens, because continuing to run with a faulty control board could be unsafe. The control board will need to be replaced by a qualified technician to get the washer working again.

Diagnostic procedure

The full F8 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Replace the control card.
Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F8 procedure $9.95

Or subscribe: $29/month for all codes plus Max AI diagnostics, with 70 Max messages a day.

Most common causes of F8

Ranked by how often they cause this code
  1. 1Internal control board component failure
  2. 2Power surge or voltage spike
  3. 3Moisture or condensation damage
  4. 4Corrupted control board firmware or logic fault

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about F8

What does F8 mean on a Asko washer?
The F8 code on an Asko washer indicates a control card fault, meaning the main electronic control board has detected an internal failure. The display will flash when this code is active. Asko specifies that the control card must be replaced to ensure complete safety, so the washer should not be operated while this fault is present.
Is it safe to use my Asko washer when it shows error code F8?
No. Asko explicitly states that the control card must be replaced to ensure complete safety when the F8 fault is present. You should not attempt to continue using the washer until the faulty control card has been replaced by a qualified technician.
How much does it cost to repair an Asko washer with an F8 error?
The cost will depend on the price of the replacement control card and the labor rate of the technician performing the repair. Control board replacements on Asko washers typically fall in the range of $200 to $500 or more depending on the specific model and parts availability. Getting a quote from an Asko-authorized service provider before proceeding is recommended.
Can I fix the F8 error on my Asko washer myself?
The prescribed repair for F8 is replacement of the control card. This involves accessing internal components and working near line voltage wiring, which carries safety risks if not handled correctly. Most homeowners will want to have a qualified appliance technician perform this repair to ensure it is done safely and correctly.
Will resetting my Asko washer clear the F8 error code?
No, a power reset will not clear the F8 error. The fault is caused by an internal hardware or logic failure within the control card itself, and the code will return even after power is disconnected and restored. The only resolution is replacing the control card.

Related ASKO washer error codes

All ASKO washer codes

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass