Crosley Washer Error Code 16

Error code 16 means the washer could not reach high spin speed during the main wash cycle. The drum never exceeded 400 RPM even though the motor was running at maximum torque for too long. The washer shuts down to prevent motor damage. This fault points to either an overloaded drum, a mechanical restriction, or a failing drive component.

A reset may clear the code temporarily, but it will return if the underlying problem is not resolved. The fault is triggered by a real operating condition, specifically the motor being unable to spin the drum past 400 RPM. Addressing the root cause, whether that is an overload, a worn belt, or a mechanical obstruction, is necessary for the error to stay cleared.

Repair costs depend on the cause. If the fix is simply reducing the load or clearing a clogged pump filter, there is no parts cost involved. A replacement drive belt typically runs in the range of $15 to $50 for parts. Drum bearing replacement or a new motor control board can bring total repair costs into the $150 to $400 range including labor, depending on the specific components needed.

Start by reducing the load size and restarting the cycle, as an overloaded drum is the most common cause. If the code returns, inspect the drive belt for wear or breakage and clear the pump filter of any debris. If mechanical components appear intact, further diagnosis of the motor and motor control board is required, which may need a technician.

You should not continue running the washer until the cause is identified. The motor was already operating at maximum torque, and continued use under that condition risks overheating or damaging the motor, drive belt, or control board. Resolve the fault before running another full cycle.