Crosley Washer Error Code 17

Error code 17 means the washer control board did not detect the door being opened after the last completed final spin cycle. The machine monitors the door actuator switch to confirm the door was accessed between cycles. If that open-door signal is never seen, the board generates this error as a protective measure. It can be caused by user behavior, a failed door switch, or a wiring fault.

A basic power reset alone is unlikely to permanently clear error code 17 if the underlying condition is still present. If the door was simply never opened between cycles, opening the door before restarting should resolve the error. If the fault is caused by a failed switch or wiring problem, the error will return after reset until the root cause is repaired.

If the fix is simply opening the door between cycles, there is no cost involved. If the door actuator switch or door lock assembly needs replacement, parts typically range from roughly 20 to 80 dollars depending on the specific component. Adding professional labor costs for diagnosis and installation, total repair expenses can range from approximately 100 to 200 dollars or more depending on local rates and the extent of the fault.

Start by simply opening the washer door fully and then attempting to start a new cycle. If the error clears, no repair is needed. If the error persists after opening the door, perform the Door Lock Test outlined on page 11 of the technical guide to check the door actuator switch for proper operation. Further diagnosis should include inspecting the switch wiring harness and connector terminals for damage or loose connections.

Error code 17 is a control-logic flag rather than an immediate safety hazard, but you should not force additional cycles while the error is active. The code exists to ensure the door interlock system is functioning correctly between cycles. Continuing to run the washer without resolving the underlying cause, especially if the door switch is faulty, could mask a door locking problem that may pose a safety concern.