Crosley Washer Error Code 18

Error code 18 on a Crosley washer means the control board detected that the door lock switch was reading as open while the motor was running. The washer expects a closed signal from the door lock switch throughout the cycle, and an open reading causes it to stop as a safety measure. The issue points to a problem with the door lock switch, its wiring, or the connectors in that circuit.

It is not advisable to continue running the washer while error code 18 is active. The error exists specifically because the control board cannot confirm the door is securely locked during machine operation. Running the washer without a confirmed door lock signal creates a risk that the door could open while the drum is spinning.

Repair costs depend on the root cause. If the fix is simply reseating a loose connector, there may be no parts cost at all. A replacement door lock assembly typically costs between $30 and $80 for the part, with professional labor adding $75 to $150 depending on your area. If the control board turns out to be the cause, costs can be significantly higher.

Clearing the diagnostic code list is actually the recommended first step when dealing with error code 18. If the fault was intermittent, the code may not return after clearing. However, if the underlying problem with the door lock switch or wiring persists, the code will reappear once the motor runs again during a cycle.

Start by clearing the diagnostic codes and running a test cycle to see if the error returns. If it does, perform the Door Lock Test procedure to isolate the fault. Check all wiring connectors at the door lock assembly for looseness or corrosion, and test the door lock switch for continuity. If the switch has failed, the door lock assembly will need to be replaced.