Crosley Washer Error Code 20

Error code 20 on a Crosley washer means the control board detected an open circuit on the door switch input during a cycle. This tells the washer that the door switch is not sending a closed signal, so the machine stops as a safety precaution. The fault can originate from a bad door switch, a wiring problem, or a door latch that is not properly engaging the switch.

No, you should not attempt to bypass or force the washer to run while error code 20 is active. The door switch circuit is a safety interlock designed to prevent the machine from operating with an unsecured door or lid. Running the washer without a functioning door switch could result in the door opening during a cycle, which poses a risk of flooding or personal injury.

Repair costs vary depending on which component is at fault. A replacement door switch typically costs between $15 and $50 for the part alone. If a technician is needed for diagnosis and replacement, total repair costs including labor generally range from $80 to $200. A door latch assembly replacement falls in a similar parts price range, while a main control board replacement would be at the higher end of the repair cost spectrum.

Start by performing the Door Lock Test as described on page 11 of the service guide to isolate the faulty component. Check the door switch for continuity with the door closed, inspect the wiring harness for breaks or loose connector pins, and examine the door latch to confirm it is fully actuating the switch. If the switch has failed, it will need to be replaced. If the wiring or latch is the issue, those components can often be repaired or replaced at lower cost.

A power reset may temporarily clear the error code display, but it will not resolve the underlying fault. If the door switch circuit is still open when the washer attempts to run, code 20 will return immediately during the next cycle. The root cause in the switch, wiring, or latch assembly must be repaired before the error will stay cleared.