Crosley Washer Error Code 22

Error code 22 on a Crosley washer means the control board is detecting a contradictory signal from the door system. The door switch is reading as open while the door locked switch is reading as locked, which cannot both be true at the same time. The washer stops the cycle and displays this code to prevent operation in an unsafe condition. The door lock assembly and its associated wiring are the primary areas to inspect.

No, you should not continue running the washer while error code 22 is active. The fault indicates the control board cannot confirm the door is properly closed and locked, which is a safety interlock. Running a wash or spin cycle with an unconfirmed door state could result in water leakage or the door opening during high-speed spinning.

Repair costs depend on which component has failed. A replacement door switch or door lock assembly typically costs between $20 and $80 for the part alone. If a technician is needed to diagnose and replace the component, expect total repair costs in the range of $100 to $250 depending on labor rates in your area. If the main control board is at fault, costs would be higher, generally ranging from $150 to $350 or more including parts and labor.

A knowledgeable DIYer can perform basic checks like inspecting the door latch for physical damage, checking wiring connections at the door lock assembly, and verifying the door closes and engages fully. However, properly diagnosing this code requires performing the Door Lock Test described in the technical documentation, which involves observing live switch signals during a test cycle. If the door switch or lock assembly needs replacement, those parts are generally accessible but require disconnecting wiring harnesses and removing the door panel.

A reset may temporarily clear the code, but it will return as soon as the washer attempts to lock the door again during a new cycle. Error code 22 reflects an ongoing hardware or wiring issue rather than a software glitch, so the underlying fault in the door switch circuit must be diagnosed and repaired for the code to stay clear.