Crosley Washer Error Code 24

Error code 24 on a Crosley washer indicates a motor over speed fault. The motor control board is detecting a tachometer signal that shows the drive motor spinning at or beyond its maximum allowable speed. The washer stops the cycle to prevent damage to internal components. The most common cause is a failing motor control board.

You should not continue using the washer while code 24 is active. The error indicates the motor may be running outside its safe speed range, which can cause damage to the motor, drum bearings, or other mechanical components. Running the machine in this condition risks worsening the repair and creating additional failures.

Unplugging the washer for a few minutes and restarting it may temporarily clear the code, but the fault will almost certainly return if the underlying component has not been repaired. Code 24 points to a hardware failure, specifically related to the motor speed control circuit, that a simple reset cannot resolve. A permanent fix requires diagnosing and replacing the faulty component.

The primary recommended step is to replace the motor control board, as it is both the most likely source of the fault and the first component called out in the diagnostic process. If replacing the board does not resolve the code, inspect the tachometer sensor on the drive motor and check the wiring harness between the motor and board for damage or loose connections. In some cases the drive motor itself may need to be replaced.

If the motor control board is the cause, parts and labor together typically range from $150 to $350 depending on the specific board and local labor rates. If the tachometer sensor or drive motor also needs replacement, total repair costs could be higher, generally in the $200 to $500 range. Getting a diagnostic assessment from a technician before purchasing parts is advisable.