Crosley Washer Error Code 28

Error code 28 on a Crosley washer indicates a valve thermistor failure. The control board has detected that the temperature sensor at the water inlet valve is reporting an abnormal resistance value, either too high or too low. This prevents the washer from confirming correct water temperature, so the cycle is stopped. The diagnostic starting point is the Wrong Water Temperature procedure.

It is not recommended to continue running the washer while error code 28 is active. The machine may not be able to verify or regulate water temperature correctly, which can affect wash performance and potentially damage certain fabrics. Address the fault before resuming normal use.

A power reset may temporarily clear the code, but if the underlying thermistor or wiring issue is still present, the fault will return during the next cycle. A reset is useful for confirming whether the fault is intermittent, but it does not fix the root cause. The thermistor circuit should be tested and repaired before relying on the washer for normal operation.

Some causes of error code 28 are DIY-friendly. Checking and reseating the thermistor wiring connector, inspecting for visible wire damage, and verifying the water supply temperature require only basic tools. Replacing the thermistor itself is also a manageable repair for someone comfortable working with appliance components. Replacing the control board is more complex and may warrant professional service.

Repair costs vary depending on which component has failed. A replacement thermistor or harness connector is typically an inexpensive part, and the repair can range from $20 to $80 in parts if done as a DIY fix. Professional labor adds to this cost, and if the control board is the cause, parts and labor combined can range from $150 to $350 or more depending on the service provider.