Crosley Washer Error Code C8

C8 indicates a communication failure between the drive board and the main control board. The two boards cannot exchange the signals needed to run the motor and complete a cycle. The washer stops operation and displays this code to alert you to the fault. You will need to inspect the wiring and connections between the boards, or replace the drive board if those check out fine.

A reset may temporarily clear the display, but C8 will return if the underlying communication fault is not corrected. Resetting alone does not fix a loose connector, corroded terminal, or defective drive board. Treat the reset as a way to confirm whether the fault is intermittent, not as a permanent fix.

If the fix is simply reseating a loose connector, there may be no parts cost at all. If the drive board needs replacement, parts and labor together typically range from around $150 to $350, depending on part availability and local labor rates. Getting a diagnosis before ordering parts is the best way to avoid unnecessary expense.

Checking and reseating the wire harness connectors between the drive board and control board is a repair many experienced DIYers can handle with basic tools. If the connectors look good and the code persists, replacing the drive board requires more comfort with appliance electronics and is often best handled by a technician.

You should not continue using the washer while C8 is active. The machine cannot operate its drive motor correctly without proper communication between the boards, which means cycles will not complete reliably. Running a washer with this kind of control fault can also risk further damage to the boards or motor.