Crosley Washer Error Code E2

The E2 code on a Crosley washer means the machine attempted to drain water from the tub but the process took longer than 10 minutes. The control board stops the cycle to prevent damage and displays this code. It can indicate either a physical blockage in the drain system or a water level sensor that is incorrectly reading a wet condition even after the tub has fully drained.

No, you should not continue running wash cycles while the E2 code is active. The error means the washer cannot properly drain, and running spin or agitation cycles with standing water in the tub can put excess stress on the motor, pump, and drum bearings. Address the drainage issue before resuming normal use.

If the fix involves only cleaning the drain hose, drain valve, or inner drain pipe, the repair cost can be minimal, often just your time. If a component like the drain valve or water level pressure sensor needs replacement, parts typically range from $15 to $80 depending on the specific component. Adding professional labor for diagnosis and repair generally brings total costs to somewhere in the $75 to $200 range.

Start by checking whether the drain hose is kinked, clogged, or installed too high on the standpipe. Next, inspect and clean the drain valve and inner drain pipe for any debris such as lint, coins, or small items. If the tub appears empty but the code persists, inspect the water level pressure sensor and its connecting hose for cracks or blockages. Clearing the physical obstruction or correcting the hose height is often all that is needed to resolve the fault.

A power reset may temporarily clear the E2 code from the display, but the code will return if the underlying drainage problem has not been resolved. Unplug the washer, wait a few minutes, and plug it back in to reset the control board. If the drain path or sensor issue is still present, the code will reappear as soon as the next drain cycle runs.