Crosley Washer Error Code E23

E23 on a Crosley washer indicates a fault in the drain pump relay circuit. The code can be triggered by a failed relay on the console control board, a disconnected or damaged wire in the pump harness, or a defective drain pump. The washer will not complete its cycle until the underlying issue is resolved.

No, you should not attempt to run the washer while E23 is active. The code indicates the drain pump circuit has failed, which means the machine cannot reliably drain water. Continuing to use it risks leaving standing water in the drum, potential overflow, or additional damage to other components.

A reset may temporarily clear the E23 code from the display, but the error will return as soon as the washer attempts to run the drain pump again if the underlying fault has not been repaired. Resetting is not a fix for this code. The control board, wiring, or drain pump must be inspected and the faulty component repaired or replaced to permanently resolve the fault.

Some causes of E23, such as a loose wire connector or a disconnected harness plug, can be addressed without specialized tools. However, replacing the control board or drain pump requires basic appliance repair skills, the ability to safely disconnect power, and access to the correct replacement parts. If you are not comfortable working inside the machine, a qualified technician should handle the repair.

Repair costs vary depending on which component has failed. A drain pump replacement typically falls in the range of $75 to $200 in parts, while a console control board can range from $100 to $300 or more depending on the model. Adding labor costs for a service technician will increase the total. Checking the wiring first is worthwhile, since a loose connector costs nothing to fix.