Crosley Washer Error Code E31

E31 on a Crosley washer means the pressure sensor is not communicating with the main control board. The pressure sensor monitors the water level in the tub, and when the board cannot receive a valid signal from it, E31 is triggered and the cycle is interrupted. The issue is most often traced to a wiring fault between the two components.

It is not recommended. The pressure sensor controls how much water enters the tub, and without reliable communication from that sensor, the washer cannot properly regulate the water level. Continuing to run the machine could result in overfilling, water damage, or additional component stress. The washer should be diagnosed and repaired before resuming normal use.

Repair costs depend on which component is at fault. If the issue is a loose connector or a damaged wire, the cost could be minimal, typically in the range of $0 to $50 for basic supplies. A replacement pressure sensor generally runs in the $20 to $80 range for the part. A new control board is the most expensive scenario, with parts and labor potentially ranging from $150 to $350 or more depending on the technician and part availability.

In many cases, yes. Start by unplugging the washer and inspecting the wiring harness and connectors between the pressure sensor and the control board, as directed by the diagnostic procedure. If a connector is loose or a wire is visibly damaged, that repair is within reach for a confident DIYer. Replacing the pressure sensor is also a straightforward part swap, but replacing the control board is more involved and may warrant a professional technician.

A reset may temporarily clear the code, but if the underlying wiring or component fault is still present, the E31 error will return once the washer attempts to read the pressure sensor again during the next cycle. Resetting is useful for confirming whether the error is intermittent, but it is not a substitute for diagnosing and correcting the actual fault.