Crosley Washer Error Code E35

E35 on a Crosley washer means the pressure sensor has detected a water overfill condition inside the drum. The washer stops operation to prevent potential flooding. Diagnosis starts by checking whether the actual water level inside the tub is above 4.5 inches to determine if the overfill is real or a sensor fault.

No, you should not run the washer while E35 is active. An overfill condition means water may exceed safe levels inside the drum, which can lead to water leaking onto the floor or damaging internal components. Leave the washer off and investigate the cause before running another cycle.

A reset may temporarily clear the E35 code, but if the underlying cause is not corrected the error will return during the next fill cycle. Resetting without addressing the inlet valve, pressure sensor, or sensor hose is not a lasting fix. Diagnose and repair the root cause to prevent the code from recurring.

Begin by checking the actual water level in the tub. If water is above 4.5 inches, the water inlet valve is likely not closing properly and should be tested or replaced. If the water level is normal, inspect the pressure sensor hose for kinks, cracks, or blockages, and then test the pressure sensor itself. Replacing the faulty component will clear the error.

Repair costs depend on which component has failed. A water inlet valve typically costs between $25 and $80 for the part, while a pressure sensor generally runs between $15 and $60. Professional labor can add $75 to $150 or more to those figures. If the issue is just a kinked or clogged hose, the repair may cost nothing.