Crosley Washer Error Code E41

E41 means the control board believes the door switch is open, indicating the door is not closed. This is a safety interlock condition that prevents the washer from operating. The fault may be caused by a door that is not fully latched, a failed door switch, or wiring problems in the door switch circuit.

No, the washer will not operate while E41 is active because this error disables the machine as a safety precaution. The door interlock system exists to prevent the drum from spinning with the door open. Do not attempt to bypass the door switch, as doing so removes an important safety feature.

If the repair only requires a door switch replacement, parts typically range from around $15 to $50 depending on the specific model, with labor adding to the total if a technician is hired. A door latch assembly replacement falls in a similar price range for the part. If the control board is at fault, that component is considerably more expensive, often ranging from $100 to $250 or more for the part alone.

Start by firmly closing the loading door to make sure it is fully latched, then try restarting the washer. If the error persists, inspect the door latch and door switch for visible damage. Testing the door switch for continuity with a multimeter will confirm whether the switch has failed and needs replacement. If the switch and wiring are both intact, the control board may need to be evaluated.

A reset may temporarily clear the error code, but if the underlying cause is not addressed, E41 will return when you attempt to run a cycle. The control board will check the door switch status at the start of every cycle, so a reset alone is not a fix. Diagnose and repair the door switch circuit to permanently resolve the fault.