Crosley Washer Error Code E47

E47 means the console control board has detected an open circuit in the door PTC circuit during the spin cycle. The PTC is a temperature-sensitive resistor that is part of the door locking system. The washer stops as a safety measure because it cannot confirm the door lock is functioning correctly at high drum speeds. Diagnosis starts with test procedure 7 to isolate the fault in the wiring, PTC component, or control board.

No, you should not attempt to bypass or ignore E47 and continue using the washer. The error code exists specifically to prevent the washer from spinning with a potentially unlocked door, which is a serious safety hazard. The washer should remain out of service until the door lock circuit has been properly diagnosed and repaired.

Repair costs depend on what component has failed. A door lock assembly typically costs between $30 and $80 for the part, while a control board can range from $100 to $250 or more. If the issue is only a damaged wire or connector, parts costs are minimal. Adding professional labor, total repair costs can range from $75 to $350 depending on the diagnosis and the parts required.

Some causes of E47, such as a loose connector or a disconnected wire, can be addressed by a confident DIYer with basic electrical knowledge and a multimeter. However, replacing the door lock assembly or the control board involves working with the washer's wiring system and requires comfort with appliance disassembly. If you are not experienced with electrical diagnostics, a qualified appliance technician is recommended.

A power reset may temporarily clear the code, but E47 will return if the underlying fault in the door PTC circuit has not been corrected. Repeatedly resetting without repairing the problem does not fix the issue and can make diagnosis more difficult. A proper repair requires identifying and correcting the open circuit in the door lock wiring or components.