Crosley Washer Error Code E48

E48 means the console control board is detecting the door PTC circuit as closed when it should not be. The PTC is a thermistor component in the door lock assembly that the control board monitors to verify door lock status. This fault prevents the washer from operating normally. Diagnosis should follow test 7 to identify whether the issue is in the door lock assembly, the wiring, or the control board.

You should not continue using the washer while the E48 error is active. The fault indicates a problem with the door lock circuit, and the control board cannot reliably confirm the door is secured. Running the washer in this condition could present a safety risk if the door lock is not functioning correctly.

A reset may temporarily clear the E48 code from the display, but it will return if the underlying problem in the door PTC circuit has not been resolved. The fault is triggered by a real electrical condition that the control board is detecting, so clearing the code without repairing the root cause will not fix the washer. Follow the test 7 diagnostic procedure to properly identify and address the cause.

Some aspects of diagnosing E48 are within reach for a knowledgeable DIYer, such as visually inspecting the wiring harness for damage or pinching. However, properly testing the PTC circuit resistance and door lock assembly requires a multimeter and familiarity with the test 7 procedure. Replacing the door lock assembly is a moderately involved repair, while replacing the control board is more complex and may be better left to a technician.

Repair costs will vary depending on which component has failed. A replacement door lock assembly typically costs between $30 and $90 for the part alone. If the control board needs replacement, parts can range from $100 to $250 or more. Adding professional labor costs will increase the total, generally ranging from $150 to $350 or higher depending on your location and the specific repair needed.