Crosley Washer Error Code E57

E57 means the inverter board has detected a high current condition in the motor drive circuit. The inverter controls the motor that spins the drum, and when current exceeds a safe level, the washer shuts down and displays this code. The fault can originate in the motor, the inverter board itself, or the wiring connecting them. Diagnostic test 9 is the recommended starting point for identifying the root cause.

No, you should stop using the washer until the cause of E57 is identified and corrected. The error represents a high current fault that the washer correctly shut down to prevent further damage. Continuing to run the machine could cause additional harm to the inverter board, motor, or wiring, potentially turning a single failed component into a more expensive multi-part repair.

Repair costs vary depending on which component has failed. If only a wiring harness needs repair or replacement, costs are generally in the lower range. An inverter board replacement typically runs in the range of $150 to $350 including parts and labor, while a drive motor replacement can range from $200 to $450 or more depending on labor rates in your area. Completing the proper diagnostic test before ordering parts helps avoid paying for components that are not actually defective.

Some basic checks are within reach of a confident DIYer, such as inspecting wiring for visible damage or trying a smaller load to rule out overloading. However, diagnosing the inverter and motor circuits requires completing a specific test procedure and using a multimeter to measure resistance and continuity. If the inverter board or motor needs replacement, most homeowners will benefit from having a qualified technician handle the repair.

Unplugging the washer for a few minutes may temporarily clear the error code, but it will almost certainly return if the underlying fault is still present. A reset does not repair a failing motor, faulty inverter board, or damaged wiring. If E57 returns after a reset, the machine needs to be properly diagnosed using the test 9 procedure before the problem will be resolved.