Crosley Washer Error Code E5A

E5A indicates that the heat sink on the speed control board has reached a dangerously high temperature. This is most commonly caused by overloading the washer drum, which forces the motor and its control electronics to work harder than intended. The washer halts operation automatically to prevent component damage when this threshold is exceeded.

No, you should not continue running the washer while E5A is active. The code means a critical electronic component is overheating, and continuing to operate the machine in this state risks permanent damage to the speed control board. Allow the unit to cool completely and address the cause before running another cycle.

If the issue is simply an overloaded drum, there is no parts cost involved. If the speed control board needs to be replaced, parts and labor costs typically range from around $150 to $350 depending on the part price and your local labor rates. Getting a diagnostic from a qualified technician first is recommended to confirm the board is at fault before purchasing parts.

Start by removing some laundry to reduce the load size, then let the washer cool down for at least 30 minutes before restarting. If the error returns with a proper load size, the speed control board should be tested by a technician. If the board tests as defective, it will need to be replaced to resolve the fault.

A reset may temporarily clear the error code, but it will return if the underlying cause is not corrected. If the fault was triggered by an overloaded drum, reducing the load size and letting the machine cool down should prevent the code from reappearing. If the speed control board is faulty, the error will return regardless of resets.