Crosley Washer Error Code E5C

The E5C code means the washer has detected a high temperature condition on the heat sink of the speed control board. The washer shuts down automatically to protect its electronics from damage. The speed control board is the primary suspect when this code appears. Replacement of the board is the recommended first step in resolving this fault.

No, you should not continue running the washer while the E5C code is active. The washer is reporting a high-temperature condition on a critical electronic board, and continued operation could cause permanent damage to the speed control board or other components. Leave the washer unplugged until the issue is diagnosed and repaired.

The cost of repair depends primarily on the price of the replacement speed control board and whether you hire a technician. Parts alone can range from roughly $80 to $250 depending on the specific model. Adding professional labor typically brings the total repair cost to somewhere in the range of $150 to $400. Getting a repair estimate before proceeding is a good idea, especially on older machines.

Replacing the speed control board is a moderately involved repair that requires comfort working with appliance electronics and disconnecting wiring harnesses. A homeowner with appliance repair experience may be able to complete it, but if you are uncertain about working with electronic control boards, calling a qualified technician is the safer choice. Always unplug the washer before beginning any repair.

Unplugging the washer for a few minutes and restarting it may temporarily clear the E5C code, but the fault is very likely to return if the underlying speed control board problem has not been addressed. A reset does not repair a failing board or correct a genuine thermal issue. Treat a recurring E5C code as confirmation that the speed control board needs to be replaced.