Crosley Washer Error Code E5E

E5E indicates a communication problem between the main control board and the speed control board. These two boards must exchange signals continuously to coordinate motor speed and cycle operation. When that communication link fails or becomes unreliable, the washer stops and displays E5E. Diagnosis should begin with Test 11, which is the designated procedure for isolating this type of fault.

No, you should not continue using the washer while E5E is active. The error means the motor control system is not functioning correctly, which could result in unpredictable motor behavior or further damage to the electronic components. Disconnect the washer from power until the fault is diagnosed and repaired.

Repair costs depend on the root cause. If the issue is a loose connector or minor wiring repair, costs may be limited to a service call fee, typically in the range of $75 to $150. If a control board requires replacement, parts and labor combined can range from $150 to $400 or more depending on which board has failed and local labor rates.

Some E5E faults are caused by loose or corroded wiring connectors, which a careful DIYer can inspect and reseat after disconnecting power to the machine. However, if the fault lies with one of the control boards, replacement requires comfort with electronics and appliance disassembly. Following the Test 11 diagnostic procedure is the correct starting point before attempting any repairs.

A power reset may temporarily clear the display, but E5E will return if the underlying communication fault has not been resolved. The reset does not repair wiring connections, board failures, or component damage. The fault must be properly diagnosed using Test 11 and the root cause corrected for the error to stay cleared.